How to use liming wax. Scrapers come in all shapes and sizes: putty knives, paint scrapers, pull scrapers, cabinet scrapers, and scraper blades (which are just pieces of metal with a sharpened edge). Hi Christine, You’ve made a lot of good insight here! As long as it’s in contact with the wood, it still works. I shared how I used Citristrip to strip the deep layers of shellac off the top of an old vintage table. 1. Strips multiple layers from wood, metal and masonry surfaces. It was latex so that made it that much easier. As I mentioned in part 1 of how to strip paint of furniture and cabinets, I’m a huge fan of Citristrip. Pour into a container and apply with a paint brush. Use a spray primer if you can find it, as spray painting the cabinet will be easier than using a brush. Removes dried latex and oil-based paint, varnish, lacquer, polyurethane and shellac. Feb 19, 2018 - How to strip paint off wood the easy way using citristrip paint stripper, a great way to refinish furniture the easily and quickly! Use CITRISTRIP Paint & Varnish Stripping and Removing Gel to remove dried latex and oil-based paint. Products shown as available are normally stocked but inventory levels cannot be guaranteed Once lifted use a scraper to remove the old finish (on wood surfaces be sure to scrape in the direction of the grain). Try to select one that won't mar the surface of wood, and use caution as you scrape. I didn’t have to sand very much at all using this method. Once it dries, it’s not as eay to scrape off. I have tried brushing it, but the crevices are deep. Even once it’s dried, believe it or not. It’s really easy to scrape paint off in the for of dust. At the time of this post, I did not own a hand sander so opted to use Citristrip to remove the stain. Allow Citristrip 20 to 30 minutes to get to work and penetrate the project surface. After you’re done, take a break: the primer must dry at least 24 hours before moving on to Step 5. If the cabinet drawer lock is sticking and not opening, you may have to pick it open. Follow the instructions on the bottle to determine how long to leave it on. If the coat hasn't completely lifted, give it more time for easy, one application removal. Be sure to read and follow the directions of the stripper product you use. You can use a pre-stain conditioner for this step. It also took far less coats of stripper than the previous door. Citristrip doing it’s thing: If you were to put the Citristrip on thick, cover it with plastic bags to hold the Citristrip against the wood and LEAVE IT ALONE, you’d get more layers off and not waste the Citristrip. In fact, it actually smells good! Use CITRISTRIP® Paint and Varnish Stripping and Removing Paste to remove multiple layers of dried latex and oil-based paint, varnish, lacquer, polyurethane and shellac from wood, metal and masonry surfaces. DIY And Crafts. Let’s start with Citristrip. Once lifted use a scraper to remove the old finish (on wood surfaces be sure to scrape in the direction of the grain). I just gave a gentle sand with 220 grit, and the door is beautifully smooth. Local store prices may vary from those displayed. I used Citristrip to assist with taking off the old stain. I would recommend using gloves tho. Pin. Put on your gloves, then brush a thick coating of Citristrip all over any area that will be stripped. Aside from that, you can also use a lacquer thinner to scrape off the remaining paint. When deciding to use all … I laid the cab down on it's side and after I removed all the paint I went over the side with a towel soaked in water.